TestProject Forum
Powered by leading experts in the test automation community

Could not read result because the message was too large

i was running the case, but recently i got this issue on swipe up, while previously it was always work on this step.
in the report is showing “Could not read result because the message was too large”
image

when i go to run it from the recording this what happen on that step
it showing expected element is missing, but if i try to find the element, the element is showing.

Hi @tri.putra, does the step fail? or does it pass and you just can’t see it in the report?

the test was failed. its there in report with this message “Could not read result because the message was too large”

It doesn’t necessarily mean the test has failed, if the message was to long the reporter won’t show it. According to the Element box the element was found.

so is there any permanent solution to this? or should i recreating the step again and use other swipe addon?

We will release new swipe addon soon, I’ll let you know when it happen.